Installing Pci Board In The 1St/2Nd Riser Card - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.11.3

Installing PCI board in the 1st/2nd Riser Card

Read the following notes first.
Please prepare the following before installing the options.
Parts included in the option kit
T-10 hexalobular driver
To install the components, follow these steps.
1. Backup all of the data in server.
2. See steps 1 to 7 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3. Remove the Riser Card by referring Chapter 2 (1.10 Riser Card).
4. Open the parts fixing the blank cover of Riser Card to direction (1) and remove the blank cover by pulling it
out to direction (4).
When installing a PCI card, make sure the connector of the card fits the connector of
Important
the Riser Card.
Check the card type (Low Profile or Full Height) which respective Riser Card supports and
Note
the type of PCI card to be installed.
To prevent personal injury, electrical shock or equipment damage, unplug the power
Important
cord and ensure no power is supplied to the server. You cannot turn off the system
power supply completely by the power button on the front panel. Until the AC power
cord is unplugged, the power supply circuit is still active in some parts of the
machine.
When running a server, always ensure proper cooling by attaching the top cover, baffle,
Note
expansion slot cover, and blank. If the server supports components with hot-plug support,
minimize the amount of time the top cover is open.
Express5800/R120h-2E User's Guide
1. Installing Internal Optional Devices
91