NEC Express5800 Series User Manual page 92

Chapter 2 Preparations
7. The necessary interior or the outside cable is connected to a PCI board. Refer to a document bundled by a
PCI board.
8. See Chapter 2 (1.9 Riser Card) to install the riser card.
9. See Chapter 2 (1.5 Top Cover) to attach the top cover of the server.
10. Please see Chapter 2 (2. Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
92

Note Make sure that the edge of a PCI card bracket is seated into the fixed slot of
the riser card.

Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.

If you have trouble installing the card, remove the card once and try again. If
you apply excessive pressure on the card, a PCI card or riser card might break.
Tips
Connector on the motherboard and PCI When doing cable juncture of a board,
before installing the riser card unit, please connect to a board.
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Important Do not touch the terminal part of riser card or PCI card and the signal pins of
electric parts installed on the board. Installing boards with dirt or oil can cause
malfunction.

Note Make sure that the edge of a PCI card bracket is seated into the fixed slot of the
riser card.

Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.

If you have trouble installing the card, remove the card once and try again. If
you apply excessive pressure on the card, a PCI card or riser card might break.
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Express5800/R120h-1E User's Guide
1. Installing Internal Optional Devices