Inventory List - Craftex CX series User Manual

INVENTORY LIST

The following is an itemized list of the items
that come with your new machine. Before
you begin following the procedures for setup
of the machine lay out everything and check
that it matches the inventory list.
A. Jointer.......................................x1
B. Fence.......................................x1
C. Fence Carriage Lock Lever...........x1
D. Fence Tilt Lock Lever..................x1
E. Carriage Assembly......................x1
F. Carriage Mounting Bracket...........x1
G. Fence Pivot Assembly..................x1
H. Locking Pin Plate........................x1
I. Limit Block.................................x1
J. Beveled Washers 10 x 3.5mm........x2
K. Infeed/Outfeed Handles................x2
L. Dust Port...................................x1
M. Dust Collection bag.....................x1
N. Dust Collection Bag Clamp...........x1
O. Push Blocks...............................x2
P. Replacement Inserts....................x5
Q. Hex Wrenches 5mm
and 6mm...............................x1 each
R. T-handle Torx Wrench T25............x1
Included Hardware
Flat Washers 8mm................................x2
Flat Washers 6mm................................x2
Lock Washers 8mm..............................x2
Lock Washers 6mm...............................x6
Flat Head Screws M5-.8x10..................x10
Cap Screws M8-1.25x30........................x4
Cap Screws M6-1x20............................x6
NOTICE
If item on list can not be found check
around machine as well as inside and
packaging materials. Sometimes items
get lost in packaging or are pre-installed
at the factory.
Large components
Small components
13