Choosing The Installation Location - Visonic PowerMaster 360 Installer's Manual

2. CHOOSING THE INSTALLATION LOCATION

2. CHOOSING THE INSTALLATION LOCATION
To ensure the best possible mounting location of the PowerMaster 360 control panel, the following points should be
observed:
•
The selected location should be approximately in the center of the installation site between all the transmitters,
preferably in a hidden location.
•
In close proximity to an AC source
•
Where there is good cellular coverage, if WCDMA-350 is used
•
Far from sources of wireless interference, such as:
o Computers or other electronic devices, power conductors, cordless phones, light dimmers, etc.
o Large metal objects (such as metal doors or refrigerators)
Note: A distance of at least 1 meter (3 ft) is recommended.
When mounting wireless devices:
•
Make sure that the signal reception level for each device is either "Strong" or "Good", but not "Poor".
•
Wireless magnetic contacts should be installed in a vertical position and as high up the door or window as possible.
•
Wireless PIR detectors should be installed upright at the height specified in their Installation Instructions
•
Repeaters should be located high on the wall in mid-distance between the transmitters and the control panel.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the control panel should be located at
a distance of at least 20 cm from all persons during normal operation. The antennas used for this product must not be
co-located or operated in conjunction with any other antenna or transmitter.
Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de son
fonctionnement normal. Les antennes utilisées pour ce produit ne doivent pas être situés ou exploités conjointement
avec une autre antenne ou transmetteur.
6 D-305735 PowerMaster 360 Installer's Guide