Broadband - Visonic PowerMaster 360 Installer's Manual

4. PROGRAMMING
Option
→
1st caller ID#
→
2nd caller ID#
(Return)

4.6.7 Broadband

Note: If the Broadband Module is not registered to the PowerMaster 360, the menu "7:BROADBAND" will not be
displayed.
In this section you can configure how to obtain an IP address, enter LAN parameters and reset broadband module
settings. In addition, the "PLNK curr.params" menu enables reading the current IP addresses of the PowerLink for
support purposes only.
04:COMMUNICATION
Enter "7:BROADBAND", select the menu to configure (see guidance above and in section 4.6.1), then refer to the
table below for configuration instructions.
Option Configuration Instructions
DHCP Client Define whether to obtain an IP address automatically using a DHCP server or to enter an
IP address manually.
Options: disable; enable (default).
Manual IP Manually enter LAN parameters.
Note: This menu will appear only if DHCP Client is disabled.
Displays the current IP addresses of the PowerLink.
PLNK curr.params
→
Displays the current PowerLink IP address.
Curr.IP address
→
Displays the current PowerLink subnet mask.
Curr.subnet mask
→
Displays the current PowerLink default gateway.
Current Gateway
Determine whether to reset the broadband module (reboot).
RESET MODULE
1
The name of the product is PowerLink3 IP Communicator
38
Configuration Instructions
Enter the "Caller ID" (i.e. telephone number) from which Monitoring Station #1 (C.S.1) /
Monitoring Station #2 (C.S.2) calls the control panel for initiating the Up/Download
process. If the sender's Caller ID matches with the "1
PowerMaster 360 will call back the PowerManage server using "IP RCVR 1" / "IP RCVR 2"
address as configured in Section 4.6.3, options 21 and 22.
Note: Caller ID#1/ID#2 must contain at least 6 digits otherwise the process will not work.
1
⋅ ⋅ ⋅
7:BROADBAND
st
caller ID#" / "2
⋅ ⋅ ⋅
MENU you wish
D-305735 PowerMaster 360 Installer's Guide
nd
caller ID#", the