1-7
Check Every 1500 Hours (Once Three Months)
1-7-1
Cleaning and Lubricating the Recognition Unit (X- and Y-axis Linear Bearings)
This unit recognizes the board and mask.
Tools
OFF (
Camera X-axis linear bearing
Camera Y-axis linear bearing
OFF (
Page 1-54
SERVO
) ON (
)
160HC1AA
SERVO
) ON (
)
Required time
5 minutes
1.
Turn off the servo switch.
2.
Open the front and rear safety covers.
3.
Clean and lubricate the linear bearing.
1.Camera X-axis linear bearing
Apply grease to the rail.
2.Camera Y-axis linear bearing
Lubricate the grease nipple.
4.
Close the front and rear safety cov-
ers.
5.
Turn on the servo switch.
1E4C-E-MMA01-A09-00