Cleaning And Lubricating The Recognition Unit (Ball Screws) - Panasonic KXF-1E4C Operating Instructions Manual

Check Every 1000 Hours (Once Two Months)
1-6-4

Cleaning and Lubricating the Recognition Unit (Ball Screws)

Tools
OFF (
160HC1AA
X-axis recognition
unit ball screw
Page 1-50
SERVO
) ON ( )
Y-axis recognition unit
ball screw
Required time 3 minutes
1.
Turn off the servo switch.
∗ When
is displayed, press the icon.
Power off
2.
Open the front and rear safety covers.
3.
Clean and lubricate the ball screws.
1.X-axis recognition unit ball screw
Apply grease to the ball screws.
2.Y-axis recognition unit ball screw
Lubricate the grease to the nipple of back.
(The picture from left arrow)
1E4C-422P
Grease nipple
1E4C-E-MMA01-A08-00