ResMed Elisee 350 Clinical Manual page 42

External DC power supply
CAUTION
Never turn the ventilator on with the power pack compartment empty. Always use the
dummy pack if no power pack is inserted.
Mains power pack located outside of the ventilator
External power supply from a vehicle
External battery pack
This is fitted and removed in the same way as the mains power pack. We recommend you
remove the external battery pack when the ventilator is switched off.
1
3
Note: An external battery pack charger is available for Li-Ion type batteries.
36/102
1
3
2
1
2
1
External
battery
pack
Mains
power
pack
2
1. Connect the external power cord to the socket on the
ventilator.
External power cord
2. Plug the other end into the connector on the mains
power pack.
3. Plug the pack into a mains power outlet and switch on
(if necessary).
1. Connect the 12–28 V DC power cord to the connector
on the ventilator.
2. Plug the power cord with the ResMed cigarette lighter
adapter attached into the cigarette lighter.
1. Place the external battery pack (blue label) in the
compartment. If it has a sufficient charge, the
ventilator will start using it.
If the external battery needs charging, use the mains
power pack and power cord:
1. Connect the power cord to the external DC power
socket on the ventilator.
2. Connect the other end of the cord to the mains power
pack.
3. Plug the pack into a mains power outlet and switch on
(if necessary).
NOT013281-8