Cleaning; Cleaning Agent / Lubricant - LinMot P10-70 Installation Manuals

Installation Guide Linear Motors
7.3.3

Cleaning


Pull the sliders carefully out of the stator.
Attention! Strong magnetic attraction forces (note safety instructions on page 5)!
Use non magnetic material (e.g. wood) to cover close-by iron constructions.

Clean slider and stator with a soft disposable paper, ideally with the help of LU06 cleaning spray (or
methylated spirits or alcohol).

Afterwards, lubricate the bore of the stators with about 2-3 g (0.1 oz) grease LU02.
There should only be a slight film of lubricant.
Note: Do not over lubricate!

Finally, slider should be lubricated according to the chapter 'mounting'.
7.3.4 Cleaning agent / Lubricant
For the cleaning of LinMot stators and sliders cleaning agent spray LU06 is recommended.
To improve the sliding characteristics between the stainless steel surface of the slider and the plastic slide
bearing the LinMot lubricant LU02 is prescribed.
Ordering information
Item Description
LU06-250 Klüberfood NH1 4-002 Spray* (250 ml)
LU02-08 Lubricant for linear motors **
LU02-50 Lubricant for linear motors **
LU02-1000 Lubricant for linear motors **
* LinMot Spray LU06 corresponds to KLÜBERFOOD NH1 4-002 which was developed for the food
processing industry.
** LinMot LU02 Lubricant corresponds to KLÜBERSYNTH UH1 14-31 which was developed for the food
processing industry.
Page 36 / 41
(8 g)
(50 g)
(1000 g)
P10-70 / P10-70-D01/02/03
ENG
Item-No.
0150-2394
0150-1953
0150-1954
0150-1955
NTI AG / LinMot