Table of Contents
Advertisement
Installation Guide Linear Motors
Maintenance of linear motors
The person responsible for the operation of the motors must ensure that the specified maintenance work is
carried out. The following maintenance schedule is designed for the operating conditions in the food industry
with contact of liquid media. The inspection cycle is 2.5 million movement cycles or 1500 friction-kilometer.
7.3.1 Maintenance schedule
When
What
Bearing tube
Wiper
Slider
Electrical connection
Every 2.5
million
movement
cycles or
Fluid cooling (if available)
1500 friction-
Tightness
kilometer
Ease of movement
7.3.2 Cleaning
•
Pull the sliders carefully out of the stator.
Attention!: Strong magnetic attraction forces (note safety instruction "contusions"
on page 5.)! Use non-magnetic material (e.g. wood) to cover close-by iron constructions.
•
Clean slider and stator with a soft disposable paper, ideally with the help of LU06 cleaning spray (or
acetone or benzene). Available cleaners in the food industry may also be used. However, these should
not leave any residues.
•
Finally, slider should be inserted according to the chapter 3.2 "Instructions for installing the linear motor".
7.3.3 Cleaning agent
All LinMot stainless steel motors have a protection class of IP69K. Standard cleaning agents in food and
pharmaceutical industries with usual concentration and amount, can be used for the cleaning. If necessary,
compatibility with the bearing material (Polyamide) and the wiper material (H-ECOPUR) must be checked.
Ordering information
Item
Description
LU06-250
Klüberfood NH1 4-002 Spray*
* LinMot Spray LU06 corresponds to KLÜBERFOOD NH1 4-002 which was developed for the food
processing industry.
NTI AG / LinMot
Task
Check + Possibly replacing the tube and the wipers in case
of visible wear. (See section 6.2)
Check whether the slider surface is clean and not scratched.
Scratched sliders must be replaced, otherwise clean the
slider. (See instruction, section 3.2)
Tighten the electrical connection between cable and stator.
Tightening torque: 0.6 Nm (Q-, J-connector) according to
section 5.3 "Connector".
Check whether the cooling circuit is permanently connected.
•
Check whether the mounting flanges are firmly bolted to
the stator without gap.
•
Tightening torque:
Cylinder screw M6 (6 Nm)
If friction is felt during movement, the motor must be stopped
immediately.
Check the alignment of the load bearing and slider.
P10-70-SSC / P10-70-SSC-D02
Item-No.
(250 ml)
0150-2394
ENG
Page 27 / 32
Advertisement
Table of Contents
