Notes On Application Of The Pr01-84X80-Ssc Series; Notes On Cleaning The Ssc Variants - LinMot PR01 Series Manual

LinMot Linear-Rotary Motors

Notes on application of the PR01-84x80-SSC series

The design of the machine should consist of a 'normal' and a 'stainless steel' zone. The 'stainless steel zone' can
be cleaned accordingly during operation. The two zones are separated by a stainless steel plate. The flange of the
Linear-Rotary motor, also made of stainless steel, is inserted through this steel plate. The cylindrical front end of
the flange has a groove with an O-ring that acts as a seal between the 'normal' and the stainless steel zones.
Picture: O-ring for sealing between 'normal' and 'stainless steel' zone .

Notes on cleaning the SSC variants

The rotary axis should not be set in motion while the line is being cleaned. It should be either fully extended or fully
retracted. The chromium steel zone has IP65 class protection. The seals are made from FKM fluorelastomer and
85 AU 20991 polyester-urethane rubber.
www.LinMot.com
NTI AG/ LinMot PR_MotorSeries-V2.6e.odt 25/71