Installation Guide Linear Motors
After the installation of the slider a safety label must be placed close to the slider.
3.7 Minimum distance from slider
3.7.1
Minimum distance from slider to slider
The sliders are made of neodymium magnets and have a strong magnetic attraction.
It must be kept a minimum distance between the sliders. This minimized the risk of bruising and secondly,
the sliders do not influence each other through their magnetic fields.
Page 12 / 41
5. Mount floating bearing
Imortant!
Do not tighten the screw!
The slider is allowed to extend into the floating bearing no
more than 15 mm!
6. Move stator (back end) to the fixed end of slider, center
slider in stator and tighten the screw.
7. Move stator (front side) to the floating bearing and
tighten screws.
P10-70 / P10-70-D01/02/03
ENG
NTI AG / LinMot