Indicator Operations; Toggle Gross/Net Mode; Toggle Units; Zero Scale - Rice Lake IQ plus 350 Installation Manual

1.4

Indicator Operations

Basic IQ plus 350 operations are summarized below:
1.4.1

Toggle Gross/Net Mode

Press the key to switch the display mode
GROSS/NET
from gross to net, or from net to gross. If a tare value
has been entered or acquired, the net value is the gross
weight minus the tare.
Gross mode is shown by the
mode is shown by the
NET
1.4.2

Toggle Units

Press the key to switch between primary and
UNITS
secondary units. The units identifier is shown in the
lower right corner of the LCD display.
1.4.3

Zero Scale

1. In gross mode, remove all weight from the
scale and wait for the standstill annunciator
( ).
2. Press the
ZERO
0
( ) annunciator lights to indicate the
scale is zeroed.
(or ) annunciator; net
G B
annunciator.
key. The center of zero
1.4.4

Acquire Tare

1. Place container on scale and wait for the
standstill annunciator (
2. Press the key to acquire the tare weight
TARE
of the container.
3. Net weight is displayed and the
annunciator lit to show the tare value was
acquired.
1.4.5

Remove Stored Tare Value

1. Remove all weight from the scale and wait for
the standstill annunciator (
2. Press the
ZERO
goes off, indicating the tare value has been
removed.
1.4.6

Print Ticket

1. Wait for the standstill annunciator (
2. Press the
PRINT
port.
).
).
T
key. The annunciator
key to send data to the serial
Introduction
T
).
3