Analog Output Menu; Version Menu - Rice Lake IQ plus 350 Installation Manual

3.2.8

Analog Output Menu

The ALGOUT menu is used only if the analog output option is installed. If the analog output option is installed,
configure all other indicator functions and calibrate the indicator (see Section 4.0 on page 25) before configuring
the analog output. See Section 7.7 on page 40 for analog output calibration procedures.
CONFIG XXXXXXX FORMAT CALIBR
SOURCE OFFSET
0%
GROSS
20%
NET
ALG OUT Menu
Parameter Choices
Level 2 submenus
SOURCE GROSS
NET
OFFSET 0%
20%
ERRACT FULLSC
HOLD
ZEROSC
MIN 000000
number
MAX 010000
number
TWZERO —
TWSPAN —
3.2.9

Version Menu

The VERS menu is used to check the software version installed in the indicator. There are no parameters
associated with the Version menu: when selected, the indicator displays the installed software version number.
CONFIG FORMAT XXXXXXX
24 IQ plus 350 Installation Manual
SERIAL PROGRM
ERRACT
FULLSC
HOLD
ZEROSC
Figure 3-12. Analog Output Menu
Specifies the source tracked by the analog output.
Zero offset. Selects whether the analog output supplies voltage (0–10 V) or current (4–20 mA)
output. Select 0% for 0–10 V output; select 20% for 4–20 mA output.
Error action. Specifies how the analog output responds to system error conditions.
Possible values are:
FULLSC: Set to full value (10 V or 20 mA)
HOLD: Hold current value
ZEROSC: Set to zero value (0 V or 4 mA)
Specifies the minimum weight value tracked by the analog output. Specify a value in the range
0–600 000.
Specifies the maximum weight value tracked by the analog output. Specify a value in the range
0–600 000.
Tweak zero. Adjust the analog output zero calibration. Use a multimeter to monitor the analog
output value. Press and hold
Tweak span. Adjust the analog output span calibration. Use a multimeter to monitor the analog
output value. Press and hold
Table 3-8. Analog Output Menu Parameters
CALIBR SERIAL PROGRM
Figure 3-13. Version Menu
PFORMT XXXXXXX DIG IN XXXXXXX ALGOUT
MIN MAX
000000 10000
number number
Description
or to adjust the output. Press
or to adjust the output. Press
PFORMT XXXXXXX DIG IN
XXXXXXX VERS
TWZERO TWSPAN
to save the new value.
to save the new value.
ALGOUT XXXXXXX XXXXXXX VERS
Software
version