Normal Mode Commands - Rice Lake IQ plus 350 Installation Manual

Command
GFMT Gross demand print format string
NFMT Net demand print format string
Command
DIGIN1 Digital input function
DIGIN2
Command
SOURCE1 Analog output source
OFFSET Zero offset
ERRACT Error action
MIN Minimum value tracked
MAX Maximum value tracked
ZERO1 Zero calibration
SPAN1 Span calibration
5.1.5

Normal Mode Commands

The serial transmit weight data commands (see Table 5-11) transmit data to the EDP port on demand The
transmit weight data commands are valid only in normal operating mode.
Command
SX Start EDP streaming
EX Stop EDP streaming
KNEWID Set or query product ID number
RS Reset system
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions
30 IQ plus 350 Installation Manual
Description
See Section 6.0 on page 32 for detailed information
Table 5-8. PFORMT EDP Commands
Description
OFF, ZERO, TARE, NT/GRS, UNITS, DSPTAR, PRINT, CLRCN,
KBDLOC, HOLD
Table 5-9. DIG IN EDP Commands
Description
GROSS, NET
0%, 20%
FULLSC, HOLD, ZEROSC
0–600 000
0–600 000
0–16 383
0–16 383
Table 5-10. ALGOUT EDP Commands
Description
Table 5-11. Normal Mode EDP Commands
Values
Values
Values
Response Format
OK or ??
OK or ??
nnnnnnn
—
nnnnnn UU
where nnnnnn is the weight value, UU is the units.
nnnnn nnnnn
See Section 7.1.2 on page 34 for detailed information about
the XE command response format.