Page 78
of soot or corrosion on the outside of the heat
brush to remove loose soot and scale from the heat
SECTION 10
10.A
If your boiler is equipped with the optional gas
After resetting, restart the boiler and observe the
to the appliance, after resetting the appliance and
supply pressure is adequate, consult the factory for
If the boiler goes through a normal
start cycle but combustion does not occur, ignitor
unplugging the ignitor plug and measuring the
If the resistance is correct, reset the boiler and
B
W
C
RADFORD
HITE
ORP.
Before proceeding, ensure
on natural gas,
of the appliance