E Locating The Appliance - Bradford White Copper Brute II Installation And Operation Instructions For

COPPER BRUTE II (500 - 2000) INSTALLATION AND OPERATING INSTRUCTIONS
in. cm
500 8 20
750 10 25
1000 10 25
1250 12 30
1500 12 30
1750 14 36
2000 14 36
1.E
The appliance should be located to provide
It should not be located in an area where leakage of
any connections will result in damage to the area
When such a location is not available, it is
recommended that a suitable drain pan, adequately
Copper Brute ll Boilers or Water Heaters must
never be installed on carpeting. The location for the
appliance should be chosen with regard to the vent
installed such that the gas ignition system components
during operation and service (circulator replacement,
Copper Brute ll must be located as close as practical
or combustion air terminal terminate through a wall,
and there is potential for snow accumulation in the
local area, both terminals should be installed at an
The dimensions and requirements that are shown
in should be met when choosing the locations
1.F
If the appliance must be installed with longer
piping runs, then larger diameter pipe or tubing shall
in. cm in. cm
6 15 6 15
8 20 8 20
8 20 8 20
10 25 12 30
10 25 12 30
12 30 12 30
12 30 12 30
.
ft. m
50 15 3
50 15 3
50 15 3
50 15 3
50 15 3
50 15 3
50 15 3
1.G
If the appliance must be installed with longer
inches
Front
Vertical
6*
Vent
Clearances.
CA001401 CA20260701
CA001402 CA20260703
CA001402 CA20260703
CA001405 CA20260706
CA001405 CA20260706
CA001404 CA20260706
CA001404 CA20260706
cm inches
1 2.5 24
1 2.5 24
1 2.5 12
1 2.5 12**
1 2.5 36
15.2*
Page 7
cm
61
61
30
30**
91