Bradford White Copper Brute II Installation And Operation Instructions For page 63

COPPER BRUTE II (500 - 2000) INSTALLATION AND OPERATING INSTRUCTIONS
adjustment of the following parameters:
• Enable Feature
• Temperature Set Point
• Proportional Gain
corrective action that is proportional to the error (set
• Integral Time
• Derivative Time
• Condensing Set Point
• Min Voltage
• Max Voltage
• Alarm Delay
• Shutdown Delay
heater will shut down and annunciate a condensing
Anti-Short Cycle
Copper Brute ll will wait the duration of the Anti-
Screen 38.
adjustment of the following parameter:
• Cycle Time – The amount of time after a heat
6.E.11.c
Wireless control is not available on this version of
6.E.11.d Warm Weather
to hydronic units only, and since it is not mandatory, it
WWSD - Shutdown Immediately
When the outdoor temperature, measured by the
upon a call for heat, the unit will not turn on to satisfy a
When the outdoor temperature, measured by the
is ide, upon a call for heat, the unit will not turn on
to satisfy a call for heat, the unit will satisfy the heat
WWWD – Disabled
When the outdoor temperature, measured by the outdoor
Page 63