Bradford White Copper Brute II Installation And Operation Instructions For page 25

COPPER BRUTE II (500 - 2000) INSTALLATION AND OPERATING INSTRUCTIONS
4.B.2
Heater
If the Copper Brute ll water heater is installed
in a closed water supply system, such as one having a
relief valve may discharge periodically, due to thermal
Contact the water supplier or local plumbing inspector
4.B.3
Heater
In a water heating application (an open system),
new water comes a fresh supply of minerals that can
also be aggressive, and can erode metals, including
with standard pumps for soft or normal water or with
of full-sized piping (same size as heater outlet) and a
for water heaters, which will enable the user to size a
the user will need to add the headloss of the piping
4.B.4
NOTE:
heater for the space heating application shall be
treatment, shall not be introduced into the potable
This water heater when used to supply potable
water shall not be connected to any heating system
or component(s) previously used with a non-potable
When the system requires water for heating at
temperatures higher than required for other uses,
an anti-scald mixing or tempering valve shall be
installed to temper the water for those uses in order
to reduce scald hazard potential.
4.B.5
Although Copper Brute ll water heaters are
installations are not recommended in areas subject to
freezing temperatures, unless proper precautions are
of system components, activation of safety devices,
heater is subjected to freezing conditions, and the
able to circulate, there is a risk of freezing in the
heater or in the pipes in the system. When water
in the system, or damage to the heater, which could
Contact the local factory representative or
Page 25
Any time a