Section 8 Burner Set Up - Bradford White Copper Brute II Installation And Operation Instructions For

COPPER BRUTE II (500 - 2000) INSTALLATION AND OPERATING INSTRUCTIONS
SECTION 8
8.A
The Copper Brute ll appliance utilizes a modular
from improper setup is not covered by the limited
is complete and fully in compliance with the
label and turn on gas and electrical power to
and pump come on for pre-purge, then the ignitor
warm-up sequence starts and after the ignitor warm-
on the ignition modules installed, the manual reset
button on the ignition modules may need to be
Range
2
7. After placing the appliance in operation, the
Burner Safety Shutoff Device must be tested
To test:
and will have to be reset before the unit will
The ignition sequence will start again and the
NOTE:
8.B
Copper Brute ll appliances may be operated at
perform equally as well, but with differing reductions in
altitude adjustment must not be made on appliances
altitude adjustment is accomplished by adjustment of
The required instruments used to assist in these
Manometer or other device capable of reading a
Propane
adjusted so that the air shutters below each blower are
from the lower side of the gas valve that is to be
( >2500 Feet )
Analyzer and a U-Tube
has been set, the manifold
Page 73
is
is