Category Iii Vent - Bradford White Copper Brute II Installation And Operation Instructions For

COPPER BRUTE II (500 - 2000) INSTALLATION AND OPERATING INSTRUCTIONS
2.B.4 Category III Vent
When the Copper Brute ll is vented with horizontal
discharge, it must be installed per this installation
manual and the venting system manufacturer's
as required in the venting system manufacturer's
venting system must be supported to prevent sagging
and may not have any low sections that could trap
The unit must not support the weight of the vent
L'appareil ne doit pas supporter le poids de la
gaine d'évent. Les parties horizontales doivent être
installées avec une pente de 2 cm/m (1/4 inch par pied)
descendant de l'appareil vers la sortie de l'évent.
WARNING
2.C
Terminals
2.C.1 Side Wall Vent Terminal
The appropriate Bradford White side wall vent
hood must be used, and is listed in the installation and
installing the vent piping through the building wall,
when installing the terminal:
appliances with condensing vents are not
permitted to terminate above a public walkway,
or over an area where condensate or vapor could
enter the building through doors, windows,
possible, locations under windows or near doors
terminal must be higher than the minimum shown
not settle on building surfaces or other nearby
combustion air from an intake terminal located
on the same wall, locate the vent terminal at least
air terminal, and locate the vent terminal at least
WARNING
AVERTISSEMENT
From Massachusetts Rules and
Regulations 248 CMR 5.08:
(a) For all side wall horizontally vented gas
fueled equipment installed in every dwelling,
building or structure used in whole or in
part for residential purposes, including those
owned or operated by the Commonwealth
and where the side wall exhaust vent
termination is less than seven (7) feet above
including but not limited to decks and
porches, the following requirements shall be
Page 13