Spraying Ga 5000Ea - WAGNER GA 5000EAIC Translation Of The Original Operating Manual

VERSION 09/2016
OPERATING MANUAL
7.3.2

SPRAYING GA 5000EA

1. Insert the desired nozzle into the spray gun.
2. Turn on the control unit.
3. Start up with product supply generator set to approx. 0.05 to 0.15 MPa; 0.5 to 1.5 bar;
7 to 22 psi operating pressure.
4. Set atomizing air regulator to approx. 2 - 4 bar.
5. Open air regulation of the gun.
6. Spray on a test object (switch gun on).
Activation of the spray gun takes place via the controller.
7. Adjust the product pressure and atomizing air in accordance with the nozzle and object.
Rule of thumb: Set atomizing air pressure approx. three times higher than the product
pressure.
Round-jet method
8. Open air regulation.
9. Changing the EARV 5000 spray jet width: Switch off high voltage. Turning the union
nut in accordance with Chapter 7.3.1.
Flat-jet method: Changing the spray jet width
8. Change the width of the spray jet by turning the air regulator (on the side of the spray
gun, see photo) or by appropriate selection of the air caps and nozzles combination.
Flow rate
9. The product quantity can be reduced by:
- Minimizing the product pressure.
- Use a diff erent nozzle size.
- Limit the valve needle stroke with the adjustment screw on the rear of the gun.
+
Air regulation fully opened.
ORDER NUMBER DOC2360924
See corresponding operating manual.
See corresponding operating manual.
See Chapter 13.
-
Air regulation closed.
B_05758
GA 5000EA
Round-jet method
Open air regulation.
The size of the air cap should
match with the nozzle size.
Flat-jet method
53