Display Screens; Fault Log Access - Baldor ID15J1F50-ER Installation And Operating Manual

Display Screens

Action
Apply Power
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key

Fault Log Access

When a fault condition occurs, motor operation stops and a fault code is
displayed on the Keypad display. The control keeps a log of the last 31 faults.
If more than 31 faults have occurred the oldest fault will be deleted from the
fault log to make room for the newest fault. To access the fault log perform the
following procedure:
Action
Apply Power
Press DISP key
Press ENTER key
Press Y key
Press RESET key
4-6 Programming and Operation
Description
Display of mode & drive status.
The fault log block.
The diagnostic information block.
The modified parameters block.
Display of output frequency.
Display of motor speed (based on
output frequency).
Display of motor current.
Display of motor voltage.
Description
Display of mode & drive status.
Press DISP to scroll to the Fault
Log entry point.
Display first fault type and time
fault occurred.
Scroll through fault messages to
the end.
Return to display mode.
Display
Display
MN715J