Programming And Operation; Overview - Baldor ID15J1F50-ER Installation And Operating Manual

Section 4

Programming and Operation

Overview

The keypad is used to program the control parameters, to operate the motor
and to monitor the status and outputs of the control (by accessing the display
options, diagnostic menus and the fault log).
JOG
Press JOG to select the preprogrammed jog speed. After the jog key has
been pressed, use the FWD or REV keys to run the motor in the direction that
is needed. The JOG key is only active in the local mode.
FWD
Press FWD to initiate forward rotation of the motor.
REV
Press REV to initiate reverse rotation of the motor.
STOP
Press STOP to initiate a stop sequence. Depending on the setup of the
control, the motor will either regen or coast to a stop. This key is operational
in all modes of operation unless it has been disabled by the Keypad Stop
parameter in the Keypad (programming) Setup Block.
LOCAL
Press LOCAL to change between the local (keypad) and remote operation.
DISP
Press DISP to return to display mode from programming mode. In the
Diagnostic menu, pressing this key will advance to the next diagnostic screen.
MN715J
Figure 4-1 Keypad
Programming and Operation 4-1