Manual Run; Home Screen - Beckman Coulter Avanti J-15 Series Instructions For Use Manual

Manual Run

When a run-parameter key (
parameter can be entered or changed.
Figure 2.1 Home Screen
To Perform a Manual Run:
1
Turn the power switch on (
2
Press
OPEN DOOR
3
Install the rotor according to the applicable rotor manual (refer to JA-10.100 Fixed-Angle Rotor
Instructions For Use (B80290) or JS-4.750 Swinging-Bucket Rotor Instructions For Use (B80289)).
Close the door.
NOTE
Before installing the rotor, ensure the drive hub is sufficiently lubricated. See
and Maintenance
PN B80286AC
SPEED, TIME, TEMPERATURE, ACCEL
1. PROGRAMS — Select to see all saved programs
2. PROGRAM NUMBER — Shows current program. If no
3. ADD PROGRAM — Select to create a new program
4. MENU — Select to see diagnostics, sound control,
5. RPM/RCF MODE toggle — Select to switch between
6. TIMED MODE/HOLD MODE toggle — Select to
7. RADIUS — Select to set radius (see Radius).
8. START — Select to start a run (see Start).
9. OPEN DOOR — Select to open the door.
10. ACCELERATION/DECELERATION PROFILE — Select
11. TEMPERATURE (J-15R only) — Displays the current
12. TIME — Displays current remaining time and set
13. SPEED (RCF showing) — Displays current speed and
).
I
to open the chamber door; lift the door open.
for instructions.
/
DECEL, RADIUS
(see Programmed Run).
program is selected, this is not shown.
(see Create a New Program).
and product information (see
RCF and RPM (see Speed).
switch between a timed run and a hold run
(see Time).
to change acceleration and deceleration rates
(see Acceleration/Deceleration).
temperature and set temperature. Select to set the
temperature (see Temperature (J-15R
time. Select to set a timed run. If Hold Mode is
selected, displays elapsed run time (see Time).
set speed. Select to change speed (see Speed).
2
Operation
Manual Run
) is selected, a
Menu Screen).
only)).
CHAPTER 4, Care
2-3