6. Installation
6-1. Mullion/Wall Mount
Drill two 3.5*40 or 3.5*25 screw holes in the designated location of the wall
6cm(2.32 ") apart vertically and drill one 12mm(0.47") hole for the controller
cable in the center of the two holes.
6-2. Pass the reader cable through the center hole and install the reader module by
using two 3.5*40 or 3.5*25 screws
6-3. Put bezel on the reader module and push bezel
장치에 덮개를 씌우고, 딸깍 소리가 날 때까지 밀어 넣으십시오.
Dec. 2016 Copyright IDTECK Co., Ltd
7
User's manual