Installation
1
Installation Steps
1.1
Drilling Screw Holes
Drill two 6-32 or M3 screw holes 3.3" (8.38cm) apart vertically, and drill one 1/2" hole for th
e reader cable between the two holes. (See the 'Figure: Installation Layout' below).
1.2
Installing the Reader Module
Put the reader cable into the center hole and hold the reader module using two 6-32 or M3
screws.
1.3
Insert Reader Module
Insert the reader module into the bezel and push it up until you hear a click.
6
p.9