Table of Contents
Advertisement
5. Specifications
CPU
Frequency
Read Range
Reading Time (Card)
Power / Current
Input Port
Output Format
LED Indicator
Beeper
Keypad
Operating Temperature
Operation Humidity
Color
Material
Dimension
(W x H x T)
Weight
Index of Protection
Certification
6. Installation
6-1. Drilling Screw Holes
Drill two 6-32 or M3 screw holes at 3.3" (8.38cm) intervals vertically.
Then, drill one 1/2" hole between previously drilled two holes. (Look at the figure: Installation Layout.)
6-2. Fixing the Reader Module
Put the reader cable into the center hole and fix the reader module using two 6-32 or M3 screws.
6-3. Putting the Cover
Put the cover on the device and push it until it clicks into place.
8bit Microprocessor
13.56MHz
ISC80S : Up to 4 inch(10cm)
Less than 1s
DC 12V, Max. 100mA
2ea(External LED Control, External Buzzer Control)
34 bit Wiegand & RS232 (Default)
With PRG2000S, various Wiegand & ABA Track II Output Programmable
3 Array LED Indicator (Red and Green)
Piezo Beeper
N /A
-35℃ to +65℃(-31℉ to 149℉)
10 to 90% RH relative humidity non-condensing
Dark Peal Gray
Polycarbonate
1.8" x 4.5" x 0.88" (47mm x 115mm x 22mm)
150g (0.33lbs)
IP65, IP66(SR10SE)
FCC, CE, KCC(MIC)
5
Advertisement
Table of Contents
