- If liquid has been spilled on the product, unplug it first. CAUTIONS ABOUT CLEANING - Do not clean the product with water. Clean gently with dry cloth or towel. - Do not use chemicals such as benzene, thinner or acetone for cleaning. Dec. 2016 Copyright IDTECK Co., Ltd...
2. General The Prox 10/10H is an elegant looking proximity reader. It can be easily mounted on door frame (mullion) or flat wall surface. The Prox10/10H is a credible product with epoxy potting that enables you to install it outside.
Color / Material Polycarbonate Dimension 49mm x 110mm x 21.5mm ( W x H x T ) (1.92” x 4.33” x 0.85”) 192g (0.42 lbs) Weight 140g (0.31 lbs) Waterproof & Dustproof IP66 Certification FCC, CE Dec. 2016 Copyright IDTECK Co., Ltd...
6-2. Pass the reader cable through the center hole and install the reader module by using two 3.5*40 or 3.5*25 screws 6-3. Put bezel on the reader module and push bezel 장치에 덮개를 씌우고, 딸깍 소리가 날 때까지 밀어 넣으십시오. Dec. 2016 Copyright IDTECK Co., Ltd...
User’s manual 7. Wire Color Table of Prox10/Prox10H SIGNAL COLOR Main Power (+12V) Power Ground (GND) Black RS232(RX) Gray Wiegand Data 0 Out Green Wiegand Data 1 Out White Buzzer Control In Blue LED Control In Yellow RS232(TX) Brown Please cut out tail connector before installation.
User’s manual 9. Operation 9-1. If power is supplied to the Prox10/10H, blue light is turned on and the reader goes into standby 9-2. Present a RF card close to the product until you hear beep sound. The LED of Prox10/10H turns into red simultaneously and the reader sends card data to the controller.
1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on another circuit. 4. Consult the dealer or an experienced radio/TV technician for help. Dec. 2016 Copyright IDTECK Co., Ltd...
(Please refer to the IDTECK webpage for more details.) 2. RMA Code will be issued after the RMA Center reviews the RMA request form. 3. Enclose the product along with the RMA Code and send it to IDTECK RMA Center. (Product without RMA Code is not accepted.) If you have any questions or problems regarding the RMA services, please contact us using the contact information below.
Page 12
User’s manual The specifications contained in this manual are subject to change without notice. 5F, Ace Techno Tower B/D, 468, Gangseo-ro, Gangseo-Gu, Seoul, 157-030, Korea Tel : +82-2-2659-0055 Fax : +82-2-2659-0086 E-mail : webmaster@idteck.com Dec. 2016 Copyright IDTECK Co., Ltd...