Table of Contents
Advertisement
9. Operation
9-1. If power is supplied to the Prox10/10H, blue light is turned on and the reader goes
into standby
9-2. Present a RF card close to the product until you hear beep sound. The LED of
Prox10/10H turns into red simultaneously and the reader sends card data to the
controller. And then, LED turns into blue and the reader goes into standby again
for next reading.
9-3. LED Control
You can change LED color setting oppositely by connecting LED Control Input wire
(Yellow wire) to Power GND. In this case, red light is turned on when the reader is
on standby and once you present RF card, the LED of RF10/20 turns into blue
simultaneously. And then, it turns into red again for next reading.
9-4. Buzzer Control
If Buzzer Control Input wire (Blue wire) is connected to Power GND, buzzer
generates sound continuously. Cards cannot be read during the buzzer is
operating.
Dec. 2016 Copyright IDTECK Co., Ltd
9
User's manual
Advertisement
Table of Contents
