Viavi OneExpert CATV User Manual page 91

Chapter 4 CATV Testing
OneCheck
Setup
To run OneCheck Test
1 Select the OneCheck icon from beneath the CATV menu header.
The "Select a test location" window appears.
2 Select the icon for the demarcation point (Tap, Ground Point or CPE)
being tested.
A graphic showing the appropriate connection schematic for this test
will appear.
3 Assign this test to a saved work order (optional but recommended).
Select the button below Work Order ID and the list of available work
orders will appear. Select one
4 Start the test by selecting the Start button at the bottom of the screen.
Results
The results screen dashboard is comprised of four areas for each of the
demarcation points:
• Upstream Ingress
• Downstream Full Scan
• DOCSIS Test
• Session Expert
Page 68
OneExpert CATV User's Guide
22121055-001, Rev000