Chapter 8 Configuring the OneExpert with StrataSync
Limit Plans
2. Enter the desired Name and optional Description.
3. When the desired data has been entered, press the Create button.
The limit Plan template appears.
Editing Limit Values and Type
Limit Plans determine when a test result will end up being a Pass or Fail or
if any result should be determined at all for that measurement.
Three locations are currently available for different limits to be set:
Tap
Ground Block
CPE location
For each item a value can be entered that corresponds to the limits of that
measurement at that location.
The Type of limit is also selectable –
Error = Pass if results meet the limit requirements or Fail if results
Page 110
OneExpert CATV User's Guide
22121055-001, Rev000