Viavi OneExpert CATV User Manual page 111

Chapter 5 Ethernet Testing
TrueSpeed testing
The TrueSpeed test screen starts automatically after selecting a profile.
5. To change server details, select Stop Test then, select Server
Settings and specify the settings.
a
b
c
d
e
6. Touch Start.
The network diagram at the top of the screen indicates test status. As
the test runs, the speedometer moves to indicate the measurement.
Green indicates the ideal rate. Blue indicates the peak rate observed
during the current measurement.
NOTE:
The green and blue measurements appear during the test only. The
speedometer returns to 0 at the end of the test.
After the test finishes, the round trip time appears above the
speedometer and the actual upload and download speeds appear
below the speedometer. for upload and download speeds.
If the test fails, an error message appears (for example, Server Busy
or Aborted Due to Excessive Loss).
7. If you wish to test again with a different profile, select the Profiles
system key, select the profile, and then touch Start.
Page 88
Specify the Destination Type (IPv4 address or DNS name).
Enter the server address.
The TrueSpeed VNF Server must be specified.
Enter the server password.
If a fallback server is desired, check the box to enable the server.
A second TrueSpeed VNF server can help to alleviate queueing.
Select the back arrow to return to the TrueSpeed test screen.
OneExpert CATV User's Guide
22121055-001, Rev000