5
Configure the instrument's IP settings to match the LAN settings by
doing one of the following:
–
If you specified IPv4 as your network mode, specify the following
settings:
IPv4 Address Mode
DHCP
Static
Setting
No additional settings.
IPv4 Address
–
IPv4 Netmask
–
IPv4 Gateway
–
IPv4 DNS Server
–
OneExpert CATV User's Guide
22121055-001, Rev000
Establishing network connections
Enter the instrument's IP address
(which will be used when accessing
the provider network).
Enter the netmask address to
indicate whether the packets are to
be routed to other networks or sub-
networks.
Enter the address for the gateway
that is used to route packets that are
not on the same subnet.
Enter the address of the DNS server.
Chapter 2 Utilities
Page 29