Configuration Tips; Table 3-1 Configuration Tips - Honeywell UDC3300 Product Manual

3.4

Configuration Tips

Introduction
22
Listed below in Table 3-1 are a few tips that will help you enter the
configuration data more quickly.
Table 3-1 Configuration Tips
Function
Displaying Groups Use the [SET UP] key to display the Set Up groups. The group
titles are listed in this section in the order that they appear in
the controller.
Displaying Use the [FUNCTION] key to display the individual parameters
Functions
under each group. The prompts are listed in the order of their
appearance in each group.
Scrolling To get to a Set Up group prompt more quickly, hold the [SET
UP] key in. To get to a Function prompt more quickly, hold the
[FUNCTION] key in. The display will scroll through the
parameters.
seconds when the [SET UP] or [FUNCTION] key is held in.
Also, [s] or [t] keys will move Group prompts forward and
backward at a rate twice as fast.
Changing values
When changing the value of a parameter, you can adjust a
quickly more significant digit in the upper display by holding in one key
[s] or [t] , and pressing the other [s] or [t] at the same time.
The adjustment will move one digit to the left. Press the key
again and you will move one more digit to the left.
Restoring to the When you change the value or selection of a parameter while
original value
in Set Up mode and decide not to enter it, press the lower
blank key once, the original value or selection will be recalled.
Exiting SET UP To exit Set Up mode, press the [LOWER DISPLAY] key.
mode
This returns the display to the same state it was in immediately
preceding entry into the Set Up mode.
Timing out from Set If you are in Set Up mode and do not press any keys for one
Up mode minute, the controller will time out and revert to the mode and
display that was being used prior to entry into Set Up mode.
Key Error When a key is pressed and the prompt "KEY ERROR" appears
in the lower display, it will be for one of the following reasons:
UDC3300 Limit Controller Product Manual
ATTENTION
The prompting scrolls at a rate of 2/3
• parameter not available
• not in Set Up mode, press [SET UP] key first
• key malfunction, do keyboard test (operation)
Tip
1/01