Reviewing A Completed Batch Or Procedure; Collecting, Entering, And Reviewing Report Parameters; Removing A Completed Batch Or Procedure - Honeywell Experion LX Operator's Manual

Reviewing a completed batch or procedure

Reviewing a completed batch or procedure
This section provides information about the tasks to review completed batch or procedure
operations.

Collecting, entering, and reviewing report parameters

Report parameters may need to be collected from a display or from a physical asset so you
can enter them in the Report Parameters tab. You may be required to manually collect the
parameters yourself, or the data may be collected for you by a Field Operator.
Entering report parameters
1. From the summary display, select the batch or procedure for which you want to enter
report parameters.
2. In the details pane, click the Report Parameters tab.
3. Enter the data values that you have collected in the New Value boxes. Only the para-
meters able to be adjusted will have entry fields. Mouse over the boxes to see tool tips
containing limit information (if it has been configured). If you enter a value outside a
configured limit an error is returned.
Report Parameters tab showing limit values for a parameter
4. Click Apply to send the values to the controller. You can then manually start the batch
or procedural operation using the command buttons provided.
Reviewing report parameters
1. From the summary display, select the completed batch or procedure for which you
want to review report parameters.
2. In the details pane, click the Report Parameters tab.
3. The Control Recipe Value for each parameter reflects the parameters used for the com-
pleted batch or procedure.

Removing a completed batch or procedure

When a batch or procedure is in a PreExecute, PostExecute, or Failed state, you can remove
it from the summary display or from the activity table on a custom display.
Honeywell 2017 286