Table of Contents
Advertisement
Editing a batch or procedure
Asterisk indicating that the Header Parameters tab contains unsaved data
Mouse over the New Value box to see a tool tip containing the acceptable minimum
and maximum values for each parameter. If you enter a value outside the acceptable
limits, an error will be returned.
Tip:
Note that entry fields are only available for parameters that can be changed;
some parameters are non-adjustable. By default, the tabs open with the non-
adjustable parameters hidden. If you want to see the non-adjustable
parameters, select the Show non-adjustable parameters check box at the
bottom of the window.
3. Continue to provide new parameter values as required, including on other tabs.
Tip:
Click Clear at any time to remove any values entered into the New Value
boxes.
The Report Parameter tab contains data you would probably only use
after the batch or procedure has completed.
4. Click Apply to send your parameter changes to the control module and then you can
manually start the batch or procedure using the Activity command buttons.
Note that when you click Apply the set of parameter changes are written to the
controller in a single operation, rather than a single parameter being updated. This
means that more than one error could be returned if there are any issues with new
values.
Honeywell 2017
259
Advertisement
Table of Contents
