Using EFM meters
Using EFM meters
This section describes how to manage Electronic Flow Measurement (EFM) meters.
Attention:
EFM data collection and export will not take place when any of the following
conditions is true:
The EFM meter is disabled (out of service)
n
The meter's controller is disabled (out of service) or has failed
n
The controller's channel is disabled (out of service) or has failed
n
In addition, when collecting configuration log data, dynamic scanning must be
enabled on the controller.
Displaying EFM meters
Calling up a Meter Detail display
To call up a Meter Detail display
1. Use any of the following methods to call up a Meter Detail display for an individual
meter.
From the System Status display, double-click on the meter in the location pane.
l
In the Station command zone, type the partial meter name or number, then click
l
Detail on the toolbar, or press F12.
Honeywell 2017
236