Dentsply Sirona Ankylos Balance C Laboratory Manual page 73

Casting the model after submerged healing
If a prosthesis is fabricated following submerged
healing, the components of the Ankylos Balance
C/ prosthetic range, that is the PickUp (open tray)
or repositioning transfer posts, are used for the
impression.
Following after healing
Fixing the Ankylos Balance C/
implant analogs
Screw the implant analogs to
the transfer abutments fixed in
the impression using the transfer
screws.
These are fixed in the Ankylos Balance C/ implant
analog.
Mucosa mask
Insulate the impression with
silicone lubricant prior to casting
and coat the area surrounding
the implant analogs with gingiva
casting material. Observe the
manufacturer's instructions for use.
If the sulcus former is smaller
than the abutment to be
selected, the mucosa mask
may impair the fit. In this
case, fit the mucosa mask after
selecting the abutment.
Casting the model
Fabricate the model using dental
stone class IV. Ensure sufficient
height to cover the lower part of
the implant analog with plaster.
Then, undo the transfer screws and
remove the impression.
Now the prosthetic abutments can
be selected.
73