Dentsply Sirona Ankylos Balance C Laboratory Manual page 88

Standard C/
Prosthetic components Ankylos® Standard C/
Various prefabricated caps are available for the
laboratory for straightforward fabrication of crowns,
bridges and bar-supported prostheses on Ankylos
Standard C/ abutments.
Ankylos Standard wax-up copings
for single crowns (white, above) and
bridges (gray, below)
Prosthetic restoration
Ankylos Standard Wax-up Coping
• For modeling crowns and bridges
for straight and angled Standard
C/ abutments
• Occlusal and lateral holes for
screw-retained suprastructures
• Also for cemented suprastructures
• Wax-up copings for single crowns
(white), ribs for rotation locking
Both wax-up copings are
manufactured from POM and
are attached, where required,
with the M 1.6 mm occlusal
hexagon retaining screw (order
no. 3105 6021) or M 1 x 0.2 lateral
hex retaining screw (order no.
3105 6051). Screws must be
ordered separately.
88
Ankylos Standard Degunorm gold copings
Ankylos Standard Gold Coping
Degunorm
• For fabricating soldered bar
restorations on straight Standard
abutments
• High-gold content Degunorm
precious metal alloy
• M 1.6 occlusal hexagon retaining
screw included
Ankylos Fixation Screws
Ankylos screw for wax-up
• For attaching the wax-up
copings on the Ankylos Standard
C/ laboratory analog during
fabrication of screw-retained
suprastructures
Ankylos M 1.6 Occlusal Hexagon
Retaining Screw
• For attaching occlusally screw-
retained crowns and bridges on
Standard C/ abutments
• For attaching the Degunorm gold
copings
• Order no. 3105 6022, 3105 6025
or 3105 6026