Dentsply Sirona Ankylos Balance C Laboratory Manual page 35

Step-by-step:
Preparing the cast
Regardless of whether you are planning a prosthetic
restoration on indexed Ankylos Regular /X abutments
or on the freely positionable Ankylos Regular C/
abutments, the impression is taken with identical
transfer posts PickUp (open tray) or repositioning
technique with the C/X mark.
Ankylos Regular C/
Ankylos Regular /X
Fixing the Ankylos Regular C/X
implant analog
Mount and screw into position the
Ankylos C/X implant analog with
the Ankylos transfer post fixed in
the impression. The implant analog
must be correctly fitted to the
transfer post in the connection
taper and index.
They are fixed in the Ankylos Regular C/X implant
analog. As an alternative the impression can be
made with Ankylos C/ transfer posts. In this case
a suprastructure can only be fabricated with freely
positionable Ankylos Regular C/ abutments, because
no index position has been transferred.
Mucosa mask
Insulate the impression with
silicone lubricant prior to casting
and coat the area around the
Ankylos C/X implant analog with
gingiva casting material. Observe
the manufacturer's directions.
Casting the model
Prepare the master cast using
dental stone class IV. Here, ensure
adequate height such that the
implant analog is covered with
plaster.
Then, loosen the transfer screw
and remove the impression.
Note: The C/ implant analog can
only be used with Regular C/
abutments.
35