Supply; Check - Dräger PM 8030 Instructions For Use Manual

Fault - Cause
-
Remedy
)iscon.lApnoea pressure
4PNOEA PRESSURE)
'aw high
'AW fl
.pnoea volume
IPNOEA VOL)
iO2 low
:I02 Ifl
lalothane high
IAP HAL A)
nflurane high
(AP ENF /f,
oflurane high
'AP IS0 fi
M 8030 fault
xxx
'MB030 INOP)
Cause
Insufficient fresh gas supply Procure adequate fresh gas supply
Mean pressure Pmean
smaller than -2 mbar
Airway pressure Paw
smaller than -7 mbar
Insufficient fresh gas supply Procure adequate fresh gas supply
Breathing or ventilation has stopped
Leak in hose system Check hose system
Upper limit value for airway
pressure has been exceeded,
Kink in ventilation hose, stenosis Check hose system on
anaesthetic machine
Pressure limit set too high Adjust pressure limit on
anaesthetic machine
Overpressure valve switched off Switch on pressure limit on
anaesthetic machine
Breathing or ventilation has stopped.
No volume expired during 15 seconds
Insufficient
fresh gas
supply
Tube blocked/kinked
Leak in hose system
Check ventilator
Procure adequate fresh gas supply
Check hose system
The inspiratory
02 concentration
is below the lower limit value
Check 02 supply. check
setting of flowmeter on blender
The appropriate anaesthetic agent
concentration in the fresh gas is
higher than the upper limit value
Check setting on anaesthetic
vaporiser
Incorrect anaesthetic agent has
been selected
Internal hardware fault
with error number
Machine is not ready
for
operation
Call DrlgerService,
give error number
* Messages in parenthesis are displayed, or printed on the peripheral machines PM 8020 and PM
8010.
Or on a
PC or on a printer.
29
c2