Table of Contents
Advertisement
Operation
Acknowledging
advisory messages
With advisory messages. such as for a faulty sensor. the
display can be cleared for measured values:
0 Confirm = the advisory message disappears: the
yellow LED goes out.
If the error has not been rectified. the advisory message
will reappear after a set period.
Suppressing
alarm tone
Press button.
The symbol > 0 < is lit; the alarm tone is switched off
for 2 minutes. During this period, any new alarms are
indicated by a single tone sequence.
The red,or yellow LED continues to flash: the text
remains. as well as the flashing displays.
with connected Monitorbus:
0 Other Drager equipment which is connected is
automatically muted. The sound can also be switched
off on the Drsger equipment which is connected.
Switching on alarm tone again:
1 Press button again.
2 Symbol disappears.
Setting alarm tone volume
4
5
only during Standby.
Keep button pressed: the alarm tone sequence
sounds after about 2 seconds.
Turn rotary knob:
clockwise
= louder
anti-clockwise
= quieter
confirming set volume:
press knob.
After switching off and then on again, the normal volume
will apply.
26
B 13
Advertisement
Table of Contents
