Table of Contents
Advertisement
E.4.7 Scanning locations with the barcode pen
Locations marked with barcode labels can be scanned using the barcode pen
(0554 0461).
1 Connect the connector of the barcode pen to the PS2 interface of the measuring
instrument.
2
Memory / Location
3 Scan the barcode: Hold the barcode pen over the white surface and then move
swiftly over the barcode label.
- If the scanned barcode is already created as a location in the measuring instrument,
this location is activated automatically.
If the scanned barcode is not yet created as a location in the instrument, a new loca-
tion is created.
See also Memory / Location , p. 23.
E.4.8 Switching the measuring instrument off
Unsaved readings are lost when the measuring instrument is switched off.
.
- Possibly: The pump starts and the measuring cells are rinsed until the shut-off thresh-
olds (O
> 20%, other parameters < 50 ppm) are reached. Rinsing lasts no more than
2
3 minutes.
- The measuring instrument switches off.
E.5 Memory / Location
All readings are allocated to the location that is activated at the time and can be saved in
the
menu. Unsaved readings are lost if the measuring instrument is switched off!
Flue gas
Locations can be created, edited and activated. (Measuring) protocols can be printed.
The special function
tocols can be printed or deleted. The entire memory (locations and protocols) can also
be cleared.
Calling up the function:
Memory / Location
.
OK
can be used to display the available memory. All pro-
Extras memory
.
OK
E. Operation
E.4 Basic operating steps
23
Advertisement
Table of Contents
