Smoke No. / Hct; Differential Pressure - TESTO 330-1 Instruction Manual

G.2.5 Smoke No. / HCT
Calling up the function:
Measurements
Enter the smoke tester no. / smoke numbers / oil derivative:
The function is only available if the chosen fuel is an oil.
1
Sm. tester no.
2
Smoke# 1 Change
3 Repeat step 2 for the other smoke numbers and oil derivative as required.
Entering the heat carrier temperature:
Heat carrier
Copy the values to the Flue gas menu:
The smoke number/HCT-values are not displayed in the menu
however, be printed or stored in a measurement protocol, together with the measure-
ment values of a flue gas measurement. In the menu
count/WTT values can be displayed in the measurement program, printed or trans-
ferred to a Pocket PC/PC.
OK Copy readings
- The
Measurements
G.2.6 Differential pressure
The gas pressure set (0554 1203) must be connected.
Dangerous mixture of gases
Danger o o f e e xplosion!
Make sure there are no leaks between the sampling point and the meas-
uring instrument.
Do not smoke or use naked flames during measurement.
Do not measure for longer than 5 min, as the drift of the pressure sensor means that
the readings could be outside the tolerance limits.
Calling up the function:
Measurements
OK Smoke No./HCT
Enter pump number
Change
Enter the value
Enter the value
Change
.
OK
menu is opened.
OK Differential press.
.
OK
.
OK
.
OK
.
OK
Memory / Location
.
OK
G. Measuring
G.2 Measurements
. They can,
Flue gas
, the smoke
39