Disassembly Instructions - ELECTRO FREEZE SLX400C Operator's Manual

8.2 Disassembly Instructions

It is important that the freezer be disassembled, washed, lubricated and sanitized
before operation. For maximum life on moving parts, disassemble and sanitize at the
end of every day of operation.
Figure 8-2
1. If there is product in the freezer, refer
2. Remove plunger rods (6, figure 8-2)
3. Remove the hand knobs (8) and
184582-01
ELECTRO FREEZE Soft Serve Models SLX400C
To avoid electrical shock or contact with moving parts, make
sure the control pad is "OFF" and that the power switch is
"OFF".
to Section 11, Closing Procedures,
11.2 Draining Product.
by lifting up and swinging the bottom
out and down.
gently pull the dispensing head (1)
straight out.
CAUTION
4. Remove the beater shaft (1, figure
8-3) from each cylinder. Then remove
breaker bar (1), scraper blades (3)
and shaft seal (3,4) from the beater
shafts. Remove the cup seals (4)
from the washer (5) on the shaft seal
assembly.
— continued
21