Meru Networks AP1000 Installation Manuals page 72

Check AP1014i LEDs
LED Color
off
cyan
green blinking
green/white alternating
Status green/blue alternating
(right LED)
slow blue blinking
rapid blue blinking
red/yellow alternating
blue/yellow alternating
LAN
Off
(left LED)
If you want to change the appearance of the LED, follow these steps:
1. From the controller, click Configuration > Devices > AP, and then select the AP.
2. Select one of these settings for the LED Mode setting:
Normal: LED is as described above
—
Blink: Sets the LED flashing; this is useful to locate an AP
—
Dark: Turns off the LED
—
3. Click OK.
60 Meru Access Point Installation Guide
State:
AP is off - either there is no power or the LEDs are
set to Off on the controller. Check the LED setting
on the controller by clicking Configuration >
Devices > AP, selecting the AP and then checking
the setting for LED Mode.
AP is booting stage 1.
AP is booting stage 2.
AP is discovering the controller.
AP is downloading a configuration from the
controller.
AP is online and enabled.
AP is online and enabled and there is activity on
one or both radios.
Some AP failure occurred; check the controller for
more details about the alarm by clicking Monitor
> Alarms > Pending Alarms.
AP is online and enabled and one or both radios
are either scanning or an admin has taken the
radio(s) down.
This LED is not used, and will always be off.
© 2013 Meru Networks, Inc.