Meru Networks AP1000 Installation Manuals page 48

Installing AP1000e
Mount AP1000e on a Wall
The AP1000e package includes a wall mount bracket that attaches directly to the wall. To mount an
AP1000e on sheet rock or wall studs, follow these steps:
1. Using the supplied wall mount bracket as a guide, mark the four holes on the wall that will anchor
the bracket in place. The four screws should be aligned to the four corners of the bracket.
2. Drill the holes as marked and attach the wall mount bracket with four screws.
3. Attach the three mounting screws supplied in the AP1000e package to the corresponding holes on
the underside of the AP. The holes are indicated in the figure below, and are highlighted by
hexagons on the AP itself.
Figure 34: AP1000e Mounting Screw Locations
4. Align the mounting screws with their corresponding holes in the bracket and press the AP against
the wall.
5. Slide the AP downwards until it locks into place. The plastic lever attached to the wall mount kit
will click, locking the device.
6. Connect the antennas to the ports on the AP.
7. Attach the PoE Ethernet cable to the Ethernet port shown in
Caution!
mistakenly be plugged into the Console port; if you do this. the AP won't power up.
Figure 35: AP1000e Ethernet Port
Console USB
port port
USB
CONSOLE
36 Meru Access Point Installation Guide
Be sure to connect the Ethernet cable to the Ethernet port. The cable can
Ethernet
port
RES E T
DC 5V
G1
Figure 35.
© 2013 Meru Networks, Inc.