Meru Networks AP1000 Installation Manuals page 62

Installing AP1014i
3. Align the mounting bracket with the AP1014i slots used for the ceiling t-bar in the previous section
(as shown in Figure
4. Press down on the tab indicated in
5. Push down on the thumbscrews provided on the mounting bracket and clip it to the ceiling bar that
will support the AP.
6. Tighten the screws to ensure that the mechanism stays locked in place.
7. Connect one end of the CAT5 (or greater) Ethernet cable with PoE to the 100/1000 Ethernet
connector shown in
Caution!
ports can be used to connect wired clients to the AP.
Figure 47: AP1014i Green Uplink Port
8. If you want to lock AP1014i in place, use the supplied locking tool to press the AP1014i locking
mechanism shown in
Figure 48: Optionally lock AP1014i
AP1000 (mounted on ceiling)
9. To unlock AP1014i, press the unlocking mechanism on the opposite side of AP1014i see
50 Meru Access Point Installation Guide
42).
Figure 42
Figure 47 below.
Be sure to connect the Ethernet cable to the green uplink port. The yellow
Figure 48.
Key
LOCK
and rotate the AP1014i into place.
Figure 46.
© 2013 Meru Networks, Inc.