Restoring Ap1000I Settings - Meru Networks AP1000 Installation Manuals

Restoring AP1000i Settings

7. Attach the legs for the mounting kit to the T-Bars in the ceiling by sliding the clips down onto each
respective bar.
8. Remove the top nut from each leg.
9. Lower the crossbar (with the AP attached) onto the legs and screw the nuts back on top of the bar.
10. Connect one end of the PoE Ethernet cable to the Ethernet connector on the AP.
Caution!
mistakenly be plugged into the Console port. If you do this. the AP won't power up.
Note:
Check that the AP1000i is operating correctly before replacing the ceiling tile to the ceiling. Verify
correct operation using the LEDs, as shown in
Restoring AP1000i Settings
Trigger the Restore mechanism to return the AP1000i to the factory default settings. This overrides any
changes that have been made from the controllers. Note that this restore mechanism differs from the
ones on the other APs. Instead of a straight paper clip, you need to use a paper clip bent at a right
angle to push the mechanism trigger located on the inside as indicated in the Figure below. Access it
through the small hole with the bent paper clip. Press and hold the button for 10 seconds. After 10
seconds, the AP reboots and comes back up with default settings.
Figure 26: AP1000i Restore Button
24 Meru Access Point Installation Guide
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
Use a shielded Cat 5e (or greater) Ethernet cable in order to comply with
international electromagnetic emissions limits.
Check AP1000i LEDs.
© 2013 Meru Networks, Inc.